TM WH throttle issue and engine start up issue.

[Corvus]

Since I've switched to DCS World i have a problem with my throttle. Every time i start with plane already on runway or cold and dark after unpausing, throttle in game is set to full power. I have to move my controller for the game to report it's proper position. Dunno if it's intended or not but it works that way on either CH throttle or TM WH throttle. I have ticked synchronise controls in options but it didn't change a thing.

 

I think that this is also connected with engine start up issue on WH throttle. To start up engines you have to move throttle from off to idle and than back again for game to register engine start up.

So conclusion:

when you start in A10 cold and dark you have your throttles set to max power even though WH throttle is set in off position. But since they are in off position until you move them just a bit from idle and back game is still reporting it in max power. In DCS A10 1.1.1.1 it's working fine right now so i think it's World issue.

 

Edit: Engines are set to full power even if no controller is connected.

Edited October 15, 2012 by Corvus

[mnrty]

In options there is a option to sync your hotas when you start a mission. I don't remember excacly what its called but the option is there. That works for me atleast

 

Edit:secondread your OP. Sorry! Early morning :p

Edited October 23, 2012 by mnrty