ATAG_chair1 Posted December 13, 2012 Share Posted December 13, 2012 I can not get the axis commands to register for the rudder or the toe brake assignments . Even thought the rudders do work on the P-51 ,but I can not get the toe brakes to work at all? :(I must have pressed and release the toe brakes 30 times last night to no avail. The Ch control manager sees these movements and I can calibrate the pedals. But they are not seen in the simulation. Link to comment Share on other sites More sharing options...
kevdawg66 Posted December 14, 2012 Share Posted December 14, 2012 I have the pro pedals for dcs world a-10c module and all i had to do was invert the toe brakes because they were recognized incorrectly. Could this be just the wear of the pedals? Link to comment Share on other sites More sharing options...
WildBillKelsoe Posted December 14, 2012 Share Posted December 14, 2012 you have to invert for default is release brakes and not 'apply' brakes as it should be. If CH control manager feels it, the software should as well.. AWAITING ED NEW DAMAGE MODEL IMPLEMENTATION FOR WW2 BIRDS Fat T is above, thin T is below. Long T is faster, Short T is slower. Open triangle is AWACS, closed triangle is your own sensors. Double dash is friendly, Single dash is enemy. Circle is friendly. Strobe is jammer. Strobe to dash is under 35 km. HDD is 7 times range key. Radar to 160 km, IRST to 10 km. Stay low, but never slow. Link to comment Share on other sites More sharing options...
Postal2 Posted December 15, 2012 Share Posted December 15, 2012 Non , en faite le palo n'est plus gerer correctement sur les nouveaux OS . Solution vous installer Xpadder , ce logiciel vous aidera à creer tout les macro désirer . ex : les axes en tant que "Z" pour les frein et de même pour les axes ! . [sIGPIC][/sIGPIC] == http://www.3rd-wing.net == Extremmmmmmmmmmeeeeeeeeeeeeeeee!!!!!!!!!!!!!!!!!!!!!! Link to comment Share on other sites More sharing options...
Recommended Posts