Jump to content

Recommended Posts

Posted

MY MAJOR PROBLEM: In 90% of cases when I start a flight with the engine running, and every time I restart a flight, the main blade flies straight off the helo. It was funny for a while watching them (well modeled!), but now I want them to stay on my helo. The game runs fine in that 10% of instances it doesn't get de-bladed on 'spawn'.

 

CONSIDERATIONS:

(1) The fact it works perfectly 10% of the time, for 'extended' periods (until I crash), indicates the add on and my configuration are fine.

(2) The fact it happens immediately on spawn (before I can press a key) or not at all indicates a raw analogue input/controller setting is the cause.

(3) I have checked all my keys/inputs and they seem fine (and work fine).

 

TRIED without success: Checking all my settings (TM Warthog), varying collective on start up (0-100%), making my own missions, and flying without the primary blade a lot (again, well modeled, but it makes for a short flight).

 

dunno.gifAny ideas appreciated guys, I'm sure it's my config but can't figure out what setting would cause this.

 

This add on is A-W-E-S-O-M-E by the way, even if my issues never went away it was well worth the money. Thankyou for modeling the Bush Ranger so well Belsimtek.

worthy.gif

Posted

Apologies, just found HuggyBear guidance on the cause in the section I should have posted this in (didn't realise the forum was partitioned post release). Looks like it is dual assigned axis (ie: rudder axis posted into HOTAS axis as well - jube issue basically).

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...