gunterlund21 Posted June 12, 2013 Posted June 12, 2013 HI all Hopefully Im not repeating a solved problem but Im having problems finding the resolution on this so here it goes. I have a three monitor setup with one 1920x1200 monitor (monitor 1) and two Lilliput cm80 touch screen monitors (monitor 2 in landscape, monitor 3 in portrait mode all with extended desktop) running black shark. I have it set up so I can run the schval on monitor 2 and the abris on monitor 3. Works great however there is no button control for the abris so I have to click in the cockpit with a mouse to change the abris screens. Ive downloaded Helios and am trying to configure it. Ive gone through the install routine for Helios as well as Gadroc's touchscreen setup routine on his site. When I go into the helios editor I note the screen setup at the top left which does not match how my monitors are set up. It list monitor 1, 2 and 3 but not in the same order as I have set up in windows 7. It shows them as monitor 1,3,2 with monitor 3 in landscape and 2 in portrait. I tried running the monitor setup in helios but it does not match it up. Im using Gadrocs old BS profile to use the abris button layout which shows on the correct monitor when running helios. My Schval however no longer functions at all on any monitor when helios is running (works fine without helios). I cant figure out how to get the monitors to align properly in helios. Any help would be appreciated. I was in Art of the Kill D#@ it!!!!
JG14_Smil Posted June 12, 2013 Posted June 12, 2013 Hello Gunterlund21, Helios is covering your shkval up because it probably needs to be in the same spot as Gadroc's opening that allows it to show through. Don't worry too much about monitor ID numbers, just do reset monitors and go with it.
gunterlund21 Posted June 13, 2013 Author Posted June 13, 2013 ok making progress. Ive created a profile that works on all of my monitors. My Abris buttons are showing on the right screen and they function with a mouse. I cant get the touch screen to work however. Ive Loaded the displaylink software for lilliputs and Ive calibrated the screen with the windows pc tablet routine. What next? I was in Art of the Kill D#@ it!!!!
JG14_Smil Posted June 13, 2013 Posted June 13, 2013 If it is seen as a device, try ADD INTERFACE and see if it shows up.
gunterlund21 Posted June 14, 2013 Author Posted June 14, 2013 Figured out the problem. Had to run the Galaxtouch software for the lilliputs. Fixed and runs as advertised. I was in Art of the Kill D#@ it!!!!
Recommended Posts