fighter1976 Posted July 5, 2013 Posted July 5, 2013 Hi! I would like to know how can I cycle between pilot, co-pilot and gunner's station in UH 1 helicopter. Many thanks!
Cookie Posted July 5, 2013 Posted July 5, 2013 By pressing 1, 2, 3 and 4 respectively. - Two miles of road lead nowhere, two miles of runway lead everywhere - Click here for system specs
Jona33 Posted July 6, 2013 Posted July 6, 2013 Make sure you engage autopilot 1st! i found out much to my surprise this does not happen automatically. And your copilot is 'not all there'.. literally! (what is wrong with the UH-1 forum area?) It does for me, occasionally it doesn't but it nearly always does. Always remember. I don't have a clue what I'm doing
Weta43 Posted July 7, 2013 Posted July 7, 2013 (edited) The logic is longer than I have to write, but essentially, if you have the sight down and you're in the co-pilots seat - it should engage - unless you've already been in the seat, disengaged it, jumped to the pilots seat, then go back to the co-pilot's etc... Don't forget there are 3 auto-pilot modes you can have. Select them before dropping the sight. Edited July 7, 2013 by Weta43 Cheers.
bilbosmeggins Posted July 7, 2013 Posted July 7, 2013 Well it's completely broken for me. I cannot engage any of the auto-pilot modes from any of the four positions, and the screen point-blank refuses to display weapon and auto-pilot status. I've checked that the keyboard combos work in setup, but, once I start flying they will not respond at all.
Recommended Posts