fjoesne Posted July 25, 2013 Posted July 25, 2013 If I start DCS and run a mission it works just fine with my multimonitor setup, but when I end one mission to start another DCS changes my setup so that every monitor is mirroring each other. When I quit DCS to correct this problem I have to reset all my display to extend the desktop again. Only workaround I have so far is to quit DCS every time I want to do another mission. This was no problem prior to updating to 1.2.5. Anyone know of a better workaround? My setup may be somewhat complicated because I have 2x24 inch running at 1200x1920 and one 1650x1050 in the middle. I have the smallest one in the middle because I have an iPad running A10 Virtual cockpit with MFCDs and some extra interface below the small screen, while the larger displays give me a peripheral. This is why I do not use eyefinity etc because it requires all displays to run the same resolution and lower resolution on the 24 inch displays are no good. Other info: HIS radeon HD 7870, windows 7, DCS 1.2.5, A10-C
TCKnight Posted August 2, 2013 Posted August 2, 2013 I have same problem... Start with 1.2.5... Try multy player...it's ok? The more you sweat in peacetime, the less you bleed in war. www.69squadrone.it [url="https://www.facebook.com/operationadriaticsea1[/url] S.O: Win7 64bit,MB: ASUS Formula IV ,CPU: AMD 965BE 3.4 @ 4.0 + Corsair Hidro H70 ,GPU: sli 2xGainward 570GTX "Golden Sample" HTC, HD: Raptor 10.000 rpm 500gb,RAM: DDR3 Corsair Extreme 1800Mhz 12gb ,Accessories:TrackIR4 6DOF, Hotas Cougar mod cubby, pro pedals, mfd pack + samsung led 8". Hotas Warthog serial 05629.
Recommended Posts