dinko.mihalic

I am not a pilot on MI8 mtv although I am flying on an ultralight aircraft, but I am working as a technician on the Mi-8 Mtv-1 and Mi-171sh. 1. The problem with the Mi-8 in DCS is that the helicopter rises into the air while the main rotor's attack angle is 3 degrees. We test the governor system at 3 degrees of attack angle where the helicopter is still on the ground. 2. A real helicopter is much more inert and slower than the DCS model. I'm not saying the model is bad, but the differences are felt. It is as if the model was made according to a real helicopter weighing 4T rather than 11T. Please don't mind me, the model is impressively complex and made ... all praise for the team.

Hello to all off you! I installed Mi8 mtv2 on my DCS world platform....must say that I m work on same helikopter....technics...electronics...navigation...and on test flights affter all! when i wanted to take off i was shocked with the flight characteristics of the model which have nothing to do with the real model .... the 3 degrees collective raises the helicopter like on 5 degrees...the model is so nervous on hover mode and often go to VERTEX!!!!!

OK!!! I don't know which version of ka 50 is this,Black Shark or Black Shark 2 on dcs world?,,,but I doing this steps in Basic Black Shark 1.0.9 and have hud on second monitor,,,but it fill with green colour after 5 sec because it work without black square below of it,,,,and I ask how to make this black square????? how look like lua script for black square???

Thanks a lot for the link. I hope you will help me a lot. I'll send a message when the thing start working!!!

Hi. I encountered a small problem building a cockpit. I came to the point where I need to make a system, with USB, that will turn on the LED or lamp information signboard. I do not know which "OUT"? controller to use. Also help me information about programming EXPORT.LUA line in this process. If I understood well the simulator program, it should be programmed in such work. Thanks for any kind of help ... I played a bit with Arduino uno controller, I think that is wrong in this case ...

Heh heh, there's no reason to be jealous, I appreciate all who are engaged in such hobbies. Also going to give any advice that will help others in the future.

I'll put some pictures once the project is composed roughly :-)

Hi, board arrived relatively quickly and is soldered. Working properly. I continue with a further embodiment in my project.