Rungaul

This seems to be pretty much it. I put in a dead zone and removed the axis for sitting up and down. Now when I show up in the pit I raise my seat and it's been gtg. There are still some issues when I go to look over my shoulder or 90 degrees of center and up that it gets wonky but I think I can fix that with some more adjustments.

I love flight sims, always have since I played subLogic Flight simulator 2 on my C64 in the 80's. The problem I have now that is making DCS so very frustrating is with my trackIR. For BMS and Elite Dangerous it works flawlessly but when I fire up the A10C its nothing but grief. The hud never stays lined up I constantly have to scootch down and reset then sit up for all the data to be displayed centered and the tracking is always glitching, especially when on a strafing run or landing. I have the sensor about 24 inches away and use the hat clip. The sensor is a few inches above head level and I wear glasses. Any idea how to remedy this. Would switching to the pro clip help? Thank you

I hate wearing hats so I figured a good solution was to put the clip on headphones. Now whenever I look down there is a dipping/ducking motion first and it's very unnatural and annoying. Does the pro clip have the same problem?

Thanks. I can't see being able to adjust the angle worth 60 dollars more if the guts are the same.

I'm guessing the combat ones are older than the others if your having difficulty with parts?

Other than the 60 dollar difference is one better than the other performance wise?

How do you use your keyboard for CDU input?

Thanks for this.

Thanks all.

So carrying a load out of 3 Mk82, 6 Mav, 2 GBU 31, 3 GBU 12 an ECM Pod and TGP as well as full 30 mm my max spd is sitting at around 260kn. Also I should mention 5200 lbs fuel. My RPM with throttle all the way up is 95%, Oil Press is 94% and Fan spd is sitting at 81%. My question is should I not be able to in level flight break 300 kn with this load out? My throttle is showing max fwd.

Thanks. It's working now.

I was trying to make Joy butt0n 4 and 15 act as the TIR reset and pause functions in TIR5 but am having no luck. Do I have to use Target to make these changes cause I am having no luck in the control section under options in DCS.

Anyone else have an issue where the throttle losses power. I noticed when I turn on my lamp that while it flickers on that the throttle disconnected then reconnects. The lamp isnt even on the same plug as my APC power par. Also after I ditched the lamp it was still sporadically doing this if I just touched the throttle. Could having a USB extension cable be an issue with power? Or do I have a loose wire in the throttle body.

Thanks all. I wanted to make sure that I didn't bugger it up.

I am just trying to figure out if the slew control ball is supposed to be rolled like a track ball or pushed in and moved like a old laptop keyboard mouse? It's been giving me grief? Thanks

Serial #: 21916 Location: New Brunswick, Canada