Frenetique

Thanks for your replies guys. I must say one other detail with respect to this problem, which makes me wonder if it is truly a hardware problem. I tried to use the keyboards bindings directly (I believe it is Ralt + . and Ralt + ; or something like that), without touching the joystick, and the problem was the same. Another detail, the command is not coming from SST, it is a direct binding in DCS (not an emulation of the keyboard bindings). EDIT: I just tried to unbind my joystick input for the radar elevation, to see if the problem would be solved (so linked to the HOTAS). It wasn't the case. I had the following behavior, the radar elevation would always try to stick to the max high altitude. Sometimes it stays at the one I want of a few seconds and then bounce litteraly back to high altitude scan. I don't know any command that would generate such behavior (like a reset or something). I insist on the fact that it is clearly moving from one given position to max altitude without any intermediate position. EDIT2: Not limited to being stuck on high altitude, sometimes it is the lower bound...

Hi everyone, First I'd like to apologize if this question has already been asked and answered, couldn't find it by searching on the forum though. :helpsmilie: I have an issue with the F15C radar elevation when in BVR mode. The problem is that the elevation carets jitter a bit and if I want to move them down or high, they move a bit and then stick back to a default position (depending on the range of scan, altitude and where the cursor is placed). So in this case I have basically no control on the radar elevation. This behavior doesn't always appear. Sometimes I get a smooth control of it, with no jittering whatsoever. :noexpression: The radar elevation has been configured on the JOY_BTN20 and 22 (corresponding to Scan zone down and up commands). There is no conflict in the binding configuration. My HOTAS is a humble Saitek X52 (older generation, the best of X52). :joystick: So if anyone has already seen such behavior and maybe have a solution, I would be glad to seen it. :smilewink: Thanks in advance for your answers ! Fly safe.

Thanks for the very quick response Falgrum ! Much appreciated :) Also is there a way to install the mods for the DCS A10C module ? Not going through DCS world I mean. Because I would love "proper neck" for the A10C :pilotfly:

Hi everyone, First of all I apologize if this subject was already mentioned somewhere, I couldn't find it. I have DCS world, FC3 and DCS A10C. I wanted to launch the campaign of the A10C from the DCS world launcher (campaign ->A10C tab -> Georgian hammer). I look at the mission planner, everything seems fine, I should start in an A10C on the runway. But when I launch the mission, I end up in a Su 25, already in flight ! I look at the map (F10) and I discover that I basically spawned as a Russian pilot in the same mission, but wrong side basically. I already saw this behaviour in the available missions ( I don't remember which ones, I was supposed to fly in an F15C and I end up in a Mig 29...). On the other hand if I launch directly DCS A10C (not going through DCS world), the Georgian hammer campaign works perfectly fine. I wanted to try through DCS World because I installed some mods (but in DCS World). I just have to be precise, this issue was there before installing any mods. So have you seen this issue ? Is there a known solution ? If I want to install a mod (such as "horse of war" or "proper neck") do I have to go through DCS World to use them ? Thanks in advance for your enlightenments ! Fly safe :thumbup: