pierre chassang

Found solution, a few lua files modified for Helios have been overwritten by update. Fortunately a backup_xxx folder is created at update and the old files can be easily reset. Don't forget the exports.lua which has no backup. Best regards Pierre

Hi, Since the build 10872 is installed, I get no more RWR, CMPS, CMSC, Clock, And UHF frequancy and channel on my second screen. Would you have a look at this. Worked fine with previous build. Best regards Pierre

BFT09 performed successfully. I think the problem was my turns was not so banked then I get out the trigger zone. Please enlarge them a little bit.

Thanks, I'll try today and report...:thumbup: May be you could enlarge the trigger zones a little bit.

Hi, I got an isue with BFT09. After going around, I climb to 120, angel 7, 260 kt, then I turn to 040 angel 7, 260 kt, then turn to 300, angel 7, 260 kt. After that no more message from instructor. I get myself at 55 NM from airport and If I try to ask vector at Batumi, instructor says "terminate, terminate... etc". What goes wrong. I'm using latest DCS world 1.5.7.10175. See pictures attached

Please, see thread: https://forums.eagle.ru/showthread.php?p=3258949#post3258949 for more information. Best regards

Please see topic for details: https://forums.eagle.ru/showthread.php?t=194252 Best regards Pierre

The problem is that no L-engine occurs during the flight even if I set the probability to 100%. Any idea?

Of course, may be because the failure is not really triggered.

Hi, I set a Hydraulic failure in the mission planner at 15 min, during 5 minutes and 100% probability. In the debriefing, the failure is present, but not in the cockpit. No warning and no pressure lost during the flight. What I did wrong You can see screenshots here: https://forums.eagle.ru/showthread.php?t=194252 Forgot to say: Random failure work, only manual ones. Thanks for help:helpsmilie: Pierre

Oh Ok! I will post there. Thank you.

The .miz file is attached, A left engine failure should happens in 5 minutes after TO. I've added 2 screenshots: Capture is the debreifing showing the failure. Capture2 shows the aircraft without failure (took after the 1st):cry: Please help Emergencies.miz

Hi, That's what I did, I set the failure into the mission builder and saved the mission. The failure appears into the debriefing but nothing happens in the aircraft. Any idea?

Hi, I set a Hydraulic failure in the mission planner at 15 min, during 5 minutes and 100% probability. In the debriefing, the failure is present, but not in the cockpit. No warning and no pressure lost during the flight. What I did wrong Thanks for help Pierre

Hi, I'm using 2 monitorsDCS World latest + A10C) 1-23" touch screen Acer. 2-24" LG monitor. Both are 1920x1080. I created a MonitorSetup file to get cockpit on the right screen (non touch screen) and nothing on the touch screen (In the goal to install Helios cockpit) Here is the file content: But, when launching DCS, (1.5.7), The first splash screen is splited over the 2 monitors and then the GUI is on the right monitor. The problem is the left monitor remains black and I can't display the MFCD's on it. When DCS is OFF I can see the MFCD on the left screen. Would you tell me what I'm doing wrong? Best regards Pierre