mmorselli

commenting out the postStructOffset definition on fake_spot.lights.fx works, and the performance increase is positive, about 8% - 10% (Pimax 5K, Huey - Caucasus), but... someone stole the glass from my Huey :D

never installed before, I used the post #804 fix, but I got this error

thanks :thumbup: Because VR. Take the A10C radio, for example, you need to set the frequency looking at the display, then pressing ACT/STBY so the value is sent to the game. It's great... if you can look at the display, but useless if you can't With DCS Bios or Keyboard Emulation I can map all A10C radio knobs into PZ69 knobs, with the help of profile dial to map them all. This is also more immersive, because it better emulates the real way that radio works last but not least, I could be engaged in missions where the radio is not needed, so those four knobs could be used for something more useful, like the HSI knob

No way to force the generic radio (i.e. the L-39 one) for all modules, even those with real radio (i.e. A10-C) ?

I finally got it, thanks! Break (delay) is ignored with just one key :thumbup:

but if you take a look to my screenshoot you can see that I had set both break and time, but the saved profile ends up with only the time value BeginPanel RadioPanelKey{1UpperSmallFreqWheelInc}\o/OSKeyPress{Second,LCONTROL + VK_V} EndPanel Just tested again with Radio Panel and keyboard emulation, same behaviour And once the sequence has been inserted, it is no longer possible to modify it.

Thanks to the latest patches on GitHub L-39 now works well in DCS Bios mode, but only with Switch Panel (PZ55) and Multi Panel (PZ70). With Radio Panel (PZ69) no command are sent to DCS (but I can receive and display the data) I would like the radio module could be used as a free module on all aircrafts, and not just as a real radio where supported. It's a great feature, but not always usable in blind mode (VR), so those knobs and buttons are lost

Another question: what exactly does Break(ms) mean in Keyboard emulation? and where does this value end up if it's not saved in the profile? BeginPanel RadioPanelKey{1UpperSmallFreqWheelInc}\o/OSKeyPress{Second,LCONTROL + VK_V} EndPanel Only the second timing is saved (Time for KeyPress) I can't check if it's saved in the program, because it's impossible to edit a sequence Right Click on the field only offers to change timing, and not to edit the sequence

Has someone managed to get the knobs work on the L-39? i.e. I would like to use one knob of PZ69 or PZ70 to turn the HSI bug - via keyboard emulation (which is currently my preferred choice) the system doesn't respond very well, I think the knobs should work differently: - while I turn the knob it should emulate a key down - when I stop rotating for more than given ms, then it should simulate a key up - via dcs bios Completely unreliable, sometimes responds, sometimes doesn't, sometimes sends a series of commands with many seconds of delay Tested with DCS-BIOS Control Reference Live Preview, and that's what I get for the Front HSI Course Set Knob: Variable Step: always moves forward about 15 degrees, regardless of the value. And only goes forward Set State: acts as variable steps, a value of 1000 means about one degree, which would be good, but only goes forward BTW, I have serious problems to make the panels work reliably via DCS Bios, as if it absorbed too much power, even if I disabled the power management and I use two very good powered USB HUBs. No problems at all on Keyboard Emulation As VR user I would prefer to use keyboard emulation because even 1fps counts, but any working solution would be appreciated