Jump to content

Reggie Bigglesworth

Members
  • Posts

    13
  • Joined

  • Last visited

1 Follower

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Thank you razo+r , that did the trick ,all stable now . again many thanks
  2. I am having an issue with the radar elevation . I have an X56 Rhino control system and have the radar up and down on a toggle switch which had allways worked in the past but recently the radar creeps down from the mid position to the lowest position . I cleared that control and went to the keyboard control and the same issue occurs .When the radar opens initially the carrot is at the lowest point of the radar elevation scale. I move it up to the center position where it then slowly decends back to the low point . It does not rise , just decends. Any advice would be appreciated
  3. Thank you for the tip .all is good now.
  4. Can anyone tell me the correct viewports for the A-10C 2 and the F-18 . If possible I would like to export them to my 2nd monitor. Thanks in advance
  5. Good afternoon Fellow DCS Pilots, After much searching I manage to successfully exported my F18C AMPCD to my second Monitor (thanks to DCS forum ). My problem now (see Attached ) is that the blurries have invaded it . Can anyone point me in the direction of where I can fix this. I have looked in the materials.lua but cant find a reference to the AMPCD . Thank you
  6. Good evening , Thank you for your reply to my query. With diligent adjusting of the contrast and brightness for each senerio I am able to get a better track , so thanks for your advice. Biggles
  7. Targets are not showing as white hot when using Maverick D and I have used boat switch to change to Infra Red . Makes it almost impossible to lock on Any assistance would be great .I have tried all levels of brightness and contrast to no avail .
  8. Hi Razo+r. Well all I can say is Thank you Thank you , that has done the trick . I did have that flight mode activated . Switched it off and now all is right with DCS World. There is so much to learn. Thanks Heaps.
  9. Thanks for the response. I have attached 4 shots for your info . Photo1 . FCS supposed to hold AOA , stated at slight climb but continued to lose altitude even with elevators showing up 15 (photo 2) Photo 3. Autopilot on BALT on and HSEL on but continues to climb even though elevators show down 11. (photo 4 ) Any thoughts.
  10. The autopilot and the FCS are not working in my F18 . I have tried the deadzone adjustment without success . my X56Rhino is new and calibrated . indicators show that the system is active the aircraft just porpoises through 10 degrees + and- AOA the stabs don't seem to react I thought about uninstalling and reinstall but cant find a way to do it. Any help would be appreciated.
  11. When I Create a mission and select and place an object on the map ,for example a static plane or vehicle , it does not show the object only the symbol. All the tutorials I have watched show the object appearing as soon as it is placed. I have just purchased the Super aircraft carrier and when I select and place it it only shows the symbol and not the carrier itself .Therefore I can not fit the carrier out for service . Can you help . Thanks.
  12. Thanks for the info .have succeeded in getting the full screen back thanks to your advice but the dual monitor still eludes me . Shall keep trying Reggie
  13. I am a new DCS convert and selected the recommended 2 monitor setting and resulted in half display and half black screen on the 1 monito (see screen shot). Can not change back as the ok button is hidden in the black half . What can I do to restore the original and how do I set up for 2 monitors . Thank you any one Reggie
×
×
  • Create New...