fighter1976 Posted October 20, 2014 Posted October 20, 2014 Hi guys! have a question; how do i turn on the HUD properly? Every time i try to launch a missile or bombs (when I start the mission from cold start) the reticle on the HUD does not appear. I can fire the missile, or launch the bomb ,but can't actually see the reticle on the HUD which made impossible to establish an impact point. Thanks
Dun_Aenghus Posted October 20, 2014 Posted October 20, 2014 There should be a button to "turn on the pipper" somewhere below right of the hud (I think). [sIGPIC][/sIGPIC]
zaelu Posted October 20, 2014 Posted October 20, 2014 You turn the sight on from right hand vertical console, the piper on by its switch on the right of the sight. The grid has a similar switch mounted on the lower side of the sight. Make sure you make the tutorial missions and also check the manual. They are really helpful. [sIGPIC][/sIGPIC] I5 4670k, 32GB, GTX 1070, Thrustmaster TFRP, G940 Throttle extremely modded with Bodnar 0836X and Bu0836A, Warthog Joystick with F-18 grip, Oculus Rift S - Almost all is made from gifts from friends, the most expensive parts at least
fighter1976 Posted October 21, 2014 Author Posted October 21, 2014 yeap' it was the bloody "emergency inverter" knob on the right console(marked with a red square around). Must turn it on and then off right before you turn on any other knob for the cold start procedure
NeilWillis Posted October 21, 2014 Posted October 21, 2014 You don't have to touch the emergency inverter switch on my install. To turn on the gunsight, there are 2 switches, 1st turn on the gun sight using RV33, then turm on the pipper and the ASP-PFD fixed net using CU24 and CU22. Also check you have the rheostats turned up - CU24 and CU21.
Recommended Posts