[REPORTED] New antenna cable doesn't connect fully

[rrohde]

Thanks ED-Devs for adding the antenna cable so that it is visible from inside the cockpit while looking over one's shoulder.

 

However, it seems as if the antenna cable is not connected to the vertical stabilizer and has a visible gap where there should be none. This gap is visible with open and closed canopies.

 

Please see screenshots attached.

 

Thanks.

Edited December 5, 2014 by rrohde

[derelor]

Good catch! Reported as ticket #28851.

[rrohde]

Thanks!

 

Now onward to the texture glitches that can be found in both the 109 and 190's rudder pedal area inside the cockpit. :)

[C6_Claymore]

The other thing about the antenna wire on the Dora is that it's not correct when the canopy is open, actually it look like it was on the 190 A series fitted with flat canopies, on the D series fitted with the bulbed canopy and later on all Ta 152 it should be completely relaxed along the fuselage when it's open.

 

Like this

[rrohde]

Good point. The lack of a pulley in the canopy frame keeps all of the antenna cable dangling outside when the canopy is open. Maybe ED could model that as well?

[derelor]

The other thing about the antenna wire on the Dora is that it's not correct when the canopy is open, actually it look like it was on the 190 A series fitted with flat canopies, on the D series fitted with the bulbed canopy and later on all Ta 152 it should be completely relaxed along the fuselage when it's open.

 

Like this

I created a ticket for it (#28890) - let's see what happens. Do you have better images where the relaxed wire can be seen?

[rrohde]

I created a ticket for it (#28890) - let's see what happens. Do you have better images where the relaxed wire can be seen?

 

Had to resort to some scalemodel pics, and here's a good one:

 

[derelor]

Had to resort to some scalemodel pics, and here's a good one:

Thanks.