Designator with multiple targets

[flupke]

Hello,

 

I have played FC3 for some time now, but I still have a problem when I face a group of 2 opponents. On the HUD, I see with the radar only one bar, or I see two bars which are very close, and I cannot designate one target or the other one easily. Most of the time, I ask my wingman to attack the first target, and when I try to select the second one, when I can, I select the same. Is there a simple way ( for instance, to zoom in to distinguish clearly between the bars? but I haven't managed to do it ) or some good practices with groups of multiple targets?

 

Flupke.

[Frostie]

Best you can do is set the target box above or below to pick top contact or bottom contact, left or right when they are merged in the horizontal plane.

[Exorcet]

Before you're in missile range, tell your wingman to break to the side. You break in the opposite direction, this will separate you by a few miles. Now the bandits must each go a different direction to attack both of you. You may need to spam the radio command if there is a lot of chatter, even if it's just your wingman spouting useless contact information.

[combatace]

Reduce the scale on the hud that way targets will show a bit higher on HUD but will be a it more separated.

[flupke]

Thank you for the tips, it really helps :)