mwheeler Posted June 29, 2015 Posted June 29, 2015 I've been trying to calibrate these pedals for over a week now. I've followed all the directions on this website, their website, and used CH's calibration as well as my PC and game calibration. Still when I try to fly with the rudder pedals the plane won't even get off the ground and it is FRUSTRATING!!! Trying not to use a lot of 4 letter words here. The plane just yaws left uncontrollably and no matter what I do with the pedals it still does it. I've tried the Axis Tune, and that doesn't work because in order for it to work I have to give full right rudder to have the dead zone centered. I've tried calibrating it that way so it would "center" out, but that didn't work either. Can someone PLEASE help me????? [sIGPIC][/sIGPIC]
King_Hrothgar Posted June 29, 2015 Posted June 29, 2015 Does windows game controllers properties say it is centered? Keep in mind that rudder is Z axis, not x/y (neutral for those is top left corner of box). In DCS, do you have rudder assigned to the rudder pedal axis or is it assigned to the toe brakes? I ask because mine were all messed up in DCS when I bought them. I had to clear all axis and button assignments for them. Additionally, are you flying a prop plane? Cause those require almost full right rudder on takeoff in DCS.
Lion13 Posted June 29, 2015 Posted June 29, 2015 (edited) http://forums.eagle.ru/showthread.php?p=2424388#post2424388 There is a sticky input and output forum that addresses your problem.:joystick: Sticky: corrupt calibration? crazy joystick response? Use this tools Fix it: Edited June 29, 2015 by Lion13 Don't give me a P-38, The props they counter-rotate, They're battered and smitten from Burma to Britain. Oh, give me operations way out on some lonely atoll, For I am too young to die, I just want to grow old. From "THE WILD BLUE YONDER" by Oscar Brand and The Roger Wilco Four
mwheeler Posted June 29, 2015 Author Posted June 29, 2015 Lion I went through the steps in that Sticky thread, and I had the same response. King... According to all of the axis calibration, the dot is top left corner like it is supposed to be and the rudder dot is in the middle (the vertical axis or whatever it would be called). I am flying the F-15C at the moment, so no right rudder necessary on takeoff like say the P-51... What control axes do you have assigned? I deleted and reassigned the axis to the right and left toe brake for the X and Y axis... and the Z axis I think is what I assigned as the rudder.... According to instructions that is what it is supposed to be set as.... [sIGPIC][/sIGPIC]
bobd Posted June 29, 2015 Posted June 29, 2015 mwheeler, have you tried CH forum for help ? Bob Church is very helpful. If I remember right they say with CH hardware calibrate with CH software, not windows. Asus ROG Z390, I9 9900K , 32 GB DDR4, EVGA GTX 2080 Ti , Win10 64, Rift CV1 & S VR
mwheeler Posted June 29, 2015 Author Posted June 29, 2015 I will check into that! Thanks... [sIGPIC][/sIGPIC]
Svend_Dellepude Posted June 30, 2015 Posted June 30, 2015 Stupid question i know, but did you assign the pedals properly in DCS? As default they are set up for pitch, roll and rudder. [sIGPIC][/sIGPIC] Win10 64, Asus Maximus VIII Formula, i5 6600K, Geforce 980 GTX Ti, 32 GB Ram, Samsung EVO SSD.
Recommended Posts