TylerTheHottie Posted November 7, 2015 Posted November 7, 2015 Hey dudes I created some missions in my editor and noticed that the lines that connect the waypoints never show up like in the main missions. Does that mean anything bad? Im not sure how to make them appear. Does it even matter?
Sryan Posted November 7, 2015 Posted November 7, 2015 are you sure that the steerpoint switch below the CDU is on flight plan mode? Check my F-15C guide
TylerTheHottie Posted November 7, 2015 Author Posted November 7, 2015 are you sure that the steerpoint switch below the CDU is on flight plan mode? like the one below the cdu display? i actually dont recall. that may be the problem. If its not it then ill be sure to annoy you veterans again.
Sryan Posted November 7, 2015 Posted November 7, 2015 (edited) Below the CDU device, mind you. not below the CDU repeater. you wanna have that one on FLT PLAN Edited November 7, 2015 by Sryan 1 Check my F-15C guide
TylerTheHottie Posted November 8, 2015 Author Posted November 8, 2015 Below the CDU device, mind you. not below the CDU repeater. you wanna have that one on FLT PLAN do you know what its on by default?
Sryan Posted November 8, 2015 Posted November 8, 2015 MISSION. so by default, you won't get your waypoint lines on the TADS Check my F-15C guide
RglsPhoto Posted November 8, 2015 Posted November 8, 2015 Normally the STEER PT should be placed at FLT PLAN(Flight Plan), so that the flight route and waypoint can be displayed in the TAD. When it is placed in MISSION, all of the waypoint which include the waypoint generated in ME and created manually by the pilot in mission(such as a target point received from JTAC) and the divert airfields will be displayed in TAD, but the flight routed would not displayed. The MARK position is used to display the mark points I7-6700K OC 4.9G, 896G SSD, 32G RAM @ 2400MHz, NH-D15 cooling system,TM Hotas Warthog,Saitek Pro Flight Rudder Pedals,TrackIr 5, BOSE M2
kombatkarl Posted November 9, 2015 Posted November 9, 2015 There is also a setting on the TAD that will turn off Flight Plan lines, but I think that is usually on by default, and is set automatically on system startup. Worth a check though.
Frederf Posted November 9, 2015 Posted November 9, 2015 It is important to know that just because knob is "WP / MARK / FLT PLN" position it doesn't mean that it is true. Every time the knob is moved that generates an event to kick the waypoint pool into the mode. But if you set MARK on this knob and then change to waypoint pool with UFC it will be in waypoint pool but knob will be in mark position. 1
Recommended Posts