Compile Campaign Utility

[Colt40Five]

Followed the instructions in the readme, but everytime I go to compile my campaign it "encounters an error and must close" any tips or should I just release it as a mission pack?

[666th_birdy]

first try compiling only two missions. Then add one more and so on until you get the error again. It must be in one of the missions.

 

If you have al lot of statics in each mission I would suggest you release it as a mission pack since LockOn only shows the statics in the first mission (!)

[Colt40Five]

If you have al lot of statics in each mission I would suggest you release it as a mission pack since LockOn only shows the statics in the first mission (!)

 

Mission pack it is then. Thanks for the tip!

[Weta43]

No - LO will show statics all through the campaign. What it might not always do is remember they were destroyed in an earlier mission..

[666th_birdy]

I've tested this and so has Pat01 and it seems that lockon versions 1.1 and up only show the statics from the first mission. Also, when checking the map after opening the second mission, the statics of the first one seem to be part of the scenery !

 

If you have found away around this please prove me wrong and explain.

[Weta43]

I'll have a look at some campaigns I used the utility to put together & see how they behave (maybe make something to test it on my install), but I thought by "LockOn only shows the statics in the first mission" you meant that statics only show up in the first mission (that there would be no statics whatsoever after the first mission) not that statics from the first mission would show throughout, but those added in later ones wouldn't.