Jump to content

Recommended Posts

Posted
...If you are staying above this an kicking out, it is probably a trimming issue. I believe (based on observed behaviour) that if the auto-hover requests more input from the auto-pilot than the auto-pilot has control authority (20%), the AP channels kick out...
Actually I have no problem with trimming, but I'll more take care on it. Thanks for heads up!

Intel i7-14700@5.6GHz | MSI RTX4080 SuperSuprimX | Corsair V. 64GB@6400MHz. | Samsung 1TB 990 PRO SSD (Win10Homex64)
Samsung G5 32" + Samsung 18" + 2x8"TFT Displays | TM Warthog Stick w/AVA Base | VPC MongoosT-50CM3 Throttle | TM MFD Cougars | Logitech G13, G230, G510, PZ55 & Farming Sim Panel | TIR5 & M.Quest3 VR
>>MY MODS<< | Discord: Devrim#1068

Posted
does auto turn to target work in trimmed hover?

Doesn't it need autohover to work?

http://www.simhq.com/_air13/images/air_430a_003.jpg

 

auto-turn only applies rudder to try to align the nose with the shkval. It does not matter what autopilot mode you are in, the only time it won't work is in Flight-Director mode.

 

In normal flight mode, it will attempt to yaw to face the shkval, regardless of your speed and direction.

 

In route mode, it will set the shkval heading as the route-mode desired heading, and actively fly the helicopter towards the shkval as if you had a waypoint set there.

 

In auto-hover, the auto-hover will continue to hold position above the waypoint while auto-turn yaws to the shkval line of sight.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...