Issue with the Brake Axis

[TAnker737]

I've been having an issue with the brakes on the MI-8. I've attached a video since it is a bit hard to explain. This is the only module I am having this problem with also.

 

When I put the brakes all the way back the brakes keep jumping up. So for example when I am taxing to the runway and try to brake just a tiny bit it will jump up instead and then go back to normal. It will keep doing this. As you can see in the video I tried to change some settings on the axis and even put a bigger deadzone but it just made it worse.

 

I'm currently using Slaw Device 109 rudders which has a high resolution sensor. Could that be the reason possibly? I'm not really sure and was wondering if anyone else had similar problems.

 

[Martillo1]

It spikes, yes. However I kind of remember it happening in the Shark too.

[Weta43]

See if you have something else mapped to the brakes at the same time...

[TAnker737]

Thanks for the reply, I tried deleting the input profile and the problem still continues.

 

Right after I posted about this issue I realized that I didn't check if other axis from my other devices would work, they don't.

I used the slider axis from my warthog throttle and the Y axis on my joystick, same thing.

All my other modules don't have this.

 

May be a small issue but would like to get it resolved.

If anyone has a suggestion it will be appreciated.

Thanks :)

[Martillo1]

It spikes, yes. However I kind of remember it happening in the Shark too.

 

I have checked and the Shark's one does not spikes anymore.

[TAnker737]

Still having the same problem, Every device does the same spiking.

[Looney]

Have you checked the Axis Tune function to see if you have something inverted or some other option set there that would interfere with the brake axis?

[TAnker737]

Sorry for the late replay.

Yes every combination in the settings same results.

I tried all my other controllers and it only spikes when I set a axis to the brakes.

I just reformatted my pc and its the same issue.

[TAnker737]

So I found a solution to the problem. I had to go into the LUA file for the controller and set the deadzone to -0.01.

 

If anyone knows the reason why?

 

[msalama]

If anyone knows the reason why?

 

No idea. But that's a weird one, since a deadzone of -0.01 would mean an overlap around the center point, wouldn't it?

[TAnker737]

Since I'm using the slider setting the deadzone is moved to left side of the axis.

I think your right about the overlapping but only for center deadzone option.