CyStryker Posted August 7, 2016 Posted August 7, 2016 (edited) Gents: look at the pcb. the three pin connectors are clearly marked pins 1, 2 and 3. existing wiring colors Joystick Hall sensors 1 Brown to ------------ Red (+) Hall sensor 2 Red -----to ----------White (output) Hall Sensor 3 Orange --------to ----Black (-ground) Hall sensor I am going over to Ian's web page for detailed instructions. Roland /CyStryker Edited August 7, 2016 by CyStryker
Thadiun Okona Posted August 7, 2016 Posted August 7, 2016 Be aware they used the same color wires for different outputs in the throttle unit if you decide to put a Hall in it (gnd and vcc are swapped) Throttle pot wiring: Orange is VCC Red is Vout Brown is Gnd Unlike hooking up a pot backwards where it just reverses its output, switching gnd and vcc will fry a Hall.
CyStryker Posted August 7, 2016 Author Posted August 7, 2016 THank u for info... I am not going to update the throttle to Hall...... I will get another great set of Mile's sensors........ Roland
Recommended Posts