[1 & 2 NOT BUGS] Auto Trim, HUD, Brakes

[Chops]

I have several issues, which are viewable in the attached track:

 

 

I created a single player, air-start mission in the Editor using the Persian Gulf Map. No wind, 29.92 and 15 degrees C

 

 

My hardware consists of a CH Products Fighterstick, Pro Throttle, and Rudder Pedals. All controls are recently calibrated in the CH Control Manager.

 

 

 

I don't have any dead zones or curves set on my hardware.

 

 

 

1. Auto Trim does not work. My aircraft will not maintain level flight. As you can see in the track, I am trying to hold 800 ft. I am only using the Control Stick to climb and descend, and did not touch trim during the entire track. Once I get the aircraft at 800 ft, I release the control stick, and you will see that the plane either climbs or descends.

 

 

2. HUD data is cut off and not completely visible. Cockpit resolution is set to 1024.

 

 

 

3. Brakes are partially set on Mission Start. AXIS are inverted.

 

 

I am not sure if Items 1 and 3 are bugs or just related to my hardware. I did previously try using small deadzones and curves on my Fighterstick, but it didn't seem to make a difference.

F-18 Pitch Instability.trk

[Chops]

Ok, if 1 and 2 are not bugs, at least explain what is going on with these issues. I posted in the Forum to get assistance on these issues.

[=Panther=]

1. I need to watch the track to understand what is happening.

2. Have you caged the HUD? By description it almost sounds like the HUD is indicating winds. You can add a little rudder to see if it centers back. If so, then you need to CAGE the HUD to center it. Look for CAGE in the controls.

3. For what ever reason, all rudder pedals start off reversed. You need to click the AXIS tune, and click the check mark for Invert. Regarding half input, if that problem exist after inverting, open windows control panel and select the device, and calibrate. BUT DON"T calibrate, click reset calibration and see if that solves your half input.