DaveRindner Posted July 10, 2018 Posted July 10, 2018 (edited) Man'o'man! This module does have its quirks. My AGM-65 will not release. No matter what I do! Master Mode A-G Master Arm ON AGM-65G selected FUSE IN Seeker UNCAGED Target caret locked AGM-65G seeker view on left panel. Weapon release -NO RELEASE! Following direction on YT I cannot get mavs to launch! Bombs work fine. Mavs are stuck on rails. RAZBAM, G*d bless their hearts. Love'em. But their modules, have the most confounding problems with procedures. Edited July 10, 2018 by DaveRindner
mvsgas Posted July 10, 2018 Posted July 10, 2018 (edited) Are you holding down the button? Have you check you mapping? Are you using the trigger or the weapons release? Is the missile pointed at the target.? If you can post a track it would be easier to see what is happening. Edited July 10, 2018 by mvsgas To whom it may concern, I am an idiot, unfortunately for the world, I have a internet connection and a fondness for beer....apologies for that. Thank you for you patience. Many people don't want the truth, they want constant reassurance that whatever misconception/fallacies they believe in are true..
DaveRindner Posted July 10, 2018 Author Posted July 10, 2018 Holding down WEAPONS RELEASE for multiple seconds, while holding ship stable. Unguided munitions release OK. AIM-9 release OK. Mavs don't. Haven't used Sidearm yet.
jojo Posted July 10, 2018 Posted July 10, 2018 I just tried AGM-65G and it does work. The thing is that you have to be sure the missile is locked = super tight gap in the middle of the target cross. To achieve that you need to move a little the TDC so it locks the target. But if you move too much it looses the ground stabilisation, and it’s a pain the a.. to lock again. (I can’t say if it’s true to life though). No lock, no firing. So you should be sure to have the last update and try again. Mirage fanatic ! I7-7700K/ MSI RTX3080/ RAM 64 Go/ SSD / TM Hornet stick-Virpil WarBRD + Virpil CM3 Throttle + MFG Crosswind + Reverb G2. Flickr gallery: https://www.flickr.com/gp/71068385@N02/728Hbi
Jumper 64 Posted July 11, 2018 Posted July 11, 2018 If you have Dcs on steam there are two conflicting commands awacs (Lwin) sensor ins (Lwin). I have the same problem.
mvsgas Posted July 11, 2018 Posted July 11, 2018 (edited) I think I know what is happening. After you lock the target, are you pressing SSS up/Forward so IRMV is boxed in the HUD? I ask because the guy in the video did not mention that ( unless I miss it) You can find instruction on the pocket guide page 83 to 87 Edited July 11, 2018 by mvsgas To whom it may concern, I am an idiot, unfortunately for the world, I have a internet connection and a fondness for beer....apologies for that. Thank you for you patience. Many people don't want the truth, they want constant reassurance that whatever misconception/fallacies they believe in are true..
Recommended Posts