Changing PCB

[Swine]

Ok I have my t50 stick and throttle working however I still have an issue. In the upper right corner of the configuer software I can’t seem to change it from version 07. I have PCB version 03. I also cannot get the “set PCB” box (figure 1 #6 in the manual) to show, it has disappeared. I assume it does that for some reason. I also have disconnected the throttle since I believe PCB 07 is for the throttle. Does anyone have any ideas on how to change your PCB? Sorry if this is confusing but I have little experience with this stuff.

Thanks

Edited November 11, 2018 by Swine

[dburne]

Can't answer on what the correct version for you might be, but in regards to not being able to change the version did you "Load Device Profile" first?

You should have a green box that says "Sync" on upper left when it is loaded.

[Swine]

I took mine apart and it’s 03. I used the picture on the forum that shows 03 -05 or 06.

Yes I did load device profile and yes it is “sync green”.

It seems to work in DCS. I’m just afraid there’s going to be a conflict down the road of some sort. Maybe there won’t be.

 

I sent Virpil a support ticket. We’ll see how that goes.

Thanks Dburne

Edited November 11, 2018 by Swine

[dburne]

I took mine apart and it’s 03. I used the picture on the forum that shows 03 -05 or 06.

Yes I did load device profile and yes it is “sync green”.

It seems to work in DCS. I’m just afraid there’s going to be a conflict down the road of some sort. Maybe there won’t be.

 

I sent Virpil a support ticket. We’ll see how that goes.

Thanks Don B

 

Your welcome, hopefully they will answer your question and get it squared away.

Let us know how you make out with it.

[Swine]

I’m sure they will. This typically happens to me and it’s an extremely easy fix. Story of my life:)

[Swine]

All good now and fixed.