Jump to content

Recommended Posts

Posted

Hello,

 

A JTAC (HUMWEE armed) should display several targets in succession.

I have tried the following:

 

WP1- Hold, Invisible, Weapons secured, FAC, FAC Group attack, Group: X

 

Trigger: If group X dead: continue group JTAC

(should now drive from WP1 to WP2)

 

WP2- FAC, attack FAC group, group Y

 

 

Upon request, JTAC will not respond. And also the trigger function is not executed.

Goals are visible to JTAC!

 

What am I doing wrong ?

What goes up, must come down !

Intel Core i7-8700, 32 GB-RAM, Nvidia GTX 1060, 6 GB GDDR5, 1TB HDD, 1000 GB 970 EVO Plus NVMe M.2 SSD, Windows 10/64, A10-C,

VKB Gunfighter IV  Ultimate, Persian Golf, F/A-18 Hornet, Tankkiller

  • 2 months later...
Posted

I tried the same and I struggled with it. It was a hit and miss sometime does work and some time does not.

 

But try to make the FAC action before the Hold action.

 

Another thing, check that all waypoints where the jtac is holding he does have a clear LOS. No terrain is masking the target. Sometimes slightly difference in terrain height will mask the target.

 

Also try to remove invisible. I found that it may block the jtac action in similar scenarios to yours.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...