majapahit Posted June 18, 2019 Posted June 18, 2019 Perhaps I'm confusing my aircraft types but, I just did couple of runs with FA-18C and VACQ vertical bore sight doesn't seem to be working? This worked before didn't it? 2.5.5.32299 @openbeta | VR goggles | Autopilot panel | Headtracker | TM HOTAS | G920 HOTAS | MS FFB 2 | Throttle Quadrants | 8600K | GTX 1080 | 64GB RAM| Win 10 x64 | Voicerecognition | 50" UHD TV monitor | 40" 1080p TV monitor | 2x 24" 1080p side monitors | 24" 1080p touchscreen |
majapahit Posted June 18, 2019 Author Posted June 18, 2019 When the HMD is on you have to go to WACQ first. HMD not used. ok that seems to be the problem, HDM is working but apparently not VACQ vertical bore sight, that's no biggy 9M works with HDM or only 9X? | VR goggles | Autopilot panel | Headtracker | TM HOTAS | G920 HOTAS | MS FFB 2 | Throttle Quadrants | 8600K | GTX 1080 | 64GB RAM| Win 10 x64 | Voicerecognition | 50" UHD TV monitor | 40" 1080p TV monitor | 2x 24" 1080p side monitors | 24" 1080p touchscreen |
Jak525 Posted June 18, 2019 Posted June 18, 2019 So to be clear, VACQ can only be entered once already in air combat maneuvering mode. To go to ACM, do sensor control switch up. Then, if HMD is off, go down to get VACQ. If HMD is on you'll need to go left to get WACQ then down to get VACQ. Yes, 9M works with the HMD - that's independent of the ACM mode. 9X will reach farther off boresight however.
majapahit Posted June 18, 2019 Author Posted June 18, 2019 .. Then, if HMD is off, go down to get VACQ. Err, this I cannot quite see working, no locking - using 9M. I did do a DCS repair. | VR goggles | Autopilot panel | Headtracker | TM HOTAS | G920 HOTAS | MS FFB 2 | Throttle Quadrants | 8600K | GTX 1080 | 64GB RAM| Win 10 x64 | Voicerecognition | 50" UHD TV monitor | 40" 1080p TV monitor | 2x 24" 1080p side monitors | 24" 1080p touchscreen |
Recommended Posts