Jump to content

Recommended Posts

Posted (edited)

Hi all,

 

Is there way to cue the sidewinder seeker head to a specific radar locked target

in TWS mode?

So far I can only get it to work in STT (but then the targets gets lock warning)or alternatively if you switch into aim-9 AACQ mode and switch on the radar it goes into Flood mode.

 

 

Regards,

 

 

Snappy

Edited by Snappy
Posted
Hi all,

 

Is there way to cue the sidewinder seeker head to a specific radar locked target

in TWS mode?

So far I can only get it to work in STT (but then the targets gets lock warningj or alternatively if you switch into aim-9 AACQ mode and switch on the radar it goes into Flood mode.

 

 

Regards,

 

 

Snappy

 

Hello,

 

Not quite sure about your doubt, but giving it a quick try - it is possible (at the least in open-beta 2.5.5.38756.)

 

Selected BVR radar mode; select TWS mode; place target designator over the radar target; lock; and the AIM-9 seeker is cued to the TWS radar target.

 

See red circle at radar screen in the pic.

Screen_191108_103038.thumb.jpg.4cc20e7a77ad9c82d8c98429c241dc6e.jpg

          Jets                                                                         Helis                                                Maps

  • FC 3                              JA 37                               Ka-50                                             Caucasus
  • F-14 A/B                       MiG-23                            Mi-8 MTV2                                     Nevada
  • F-16 C                           MiG-29                      
  • F/A-18 C                       Mirage III E                                                         
  • MiG-21 bis                    
  • Mirage 2000 C

         i7-4790 K , 16 GB DDR3 , GTX 1660 Ti 6GB , Samsung 860 QVO 1TB

Posted

Hi Top jockey,

 

thank you for your reply with the picture.Just so I understand your steps correctly :

You press „2“ to get into BVR.Then change into TWS mode.

Then after locking the target in TWS you pressed „D“ to cycle through the weapons until you got aim-9 and the seeker was cued to locked target?

 

 

Kind regards,

 

 

Snappy

Posted (edited)
Hi Top jockey,

 

thank you for your reply with the picture.Just so I understand your steps correctly :

You press „2“ to get into BVR.Then change into TWS mode.

Then after locking the target in TWS you pressed „D“ to cycle through the weapons until you got aim-9 and the seeker was cued to locked target?

 

 

Kind regards,

 

 

Snappy

 

Yeah, it was pretty much it except that:

- the AIM-9 was selected probably before the BVR mode if I recall coorrectly;

- most of the commands were given by Joystick and Throttle.

 

And as you can see by the pic the radar is in TWS mode...

Edited by Top Jockey

          Jets                                                                         Helis                                                Maps

  • FC 3                              JA 37                               Ka-50                                             Caucasus
  • F-14 A/B                       MiG-23                            Mi-8 MTV2                                     Nevada
  • F-16 C                           MiG-29                      
  • F/A-18 C                       Mirage III E                                                         
  • MiG-21 bis                    
  • Mirage 2000 C

         i7-4790 K , 16 GB DDR3 , GTX 1660 Ti 6GB , Samsung 860 QVO 1TB

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...