fl0w Posted December 25, 2019 Posted December 25, 2019 I have read somewhere about on these subforums that disabling the EFCS mode from AUTO was a bug and has since been fixed, which was used to get raw control of the surfaces. From what I understand, once you pass 23 or so AoA units, you are able to turn on direct mode switch to over-limit the g-limiter. I have tried this, but have got no luck. Is there another particular bind that I am not aware of that is able to do this? Thanks in advance. :(
Tiger-II Posted December 26, 2019 Posted December 26, 2019 As I understood it, the switch can be moved, but it is the FUNCTION that disappears below 23 deg. AoA (it's not required). i.e. it is a part-time override, not a condition for selection. I don't think it is a solenoid switch or otherwise latched (if it was, then it would be awkward to use if you first had to wait for > 23 deg. AoA to enable it). Motorola 68000 | 1 Mb | Debug port "When performing a forced landing, fly the aircraft as far into the crash as possible." - Bob Hoover. The JF-17 is not better than the F-16; it's different. It's how you fly that counts. "An average aircraft with a skilled pilot, will out-perform the superior aircraft with an average pilot."
foxwxl Posted December 26, 2019 Posted December 26, 2019 Direct Link only activating when AOA is above normal limit, it's not for pilot to override G limitor. Also the EFCS is for emergency landing not for dogfighting. Deka Ironwork Tester Team
Recommended Posts