exile2256 Posted February 8, 2020 Posted February 8, 2020 I can’t seem to get the pp points from the mission editor, to actually be imported into the jet. I name the points eg “PP1” under the dedicated tab. When I load the data cartridge etc they’re not present in the weapon pp mode. They do work from the f10 map however. I assume it’s my fault. I checked the known issue list, couldn’t see it there.
foxwxl Posted February 8, 2020 Posted February 8, 2020 It's not about naming a WPT to PP1. Set all your route in ME, select the TGT WPT, use the "Navigation Target Points" function(a square mark right of loadout page) to mark your PP or RP, and write the PP1 or RP1 into the Comment area. DTC will load the PP/RP, if U do all the above correctly. Deka Ironwork Tester Team
exile2256 Posted February 8, 2020 Author Posted February 8, 2020 It's not about naming a WPT to PP1. Set all your route in ME, select the TGT WPT, use the "Navigation Target Points" function(a square mark right of loadout page) to mark your PP or RP, and write the PP1 or RP1 into the Comment area. DTC will load the PP/RP, if U do all the above correctly. That’s what I do, I don’t name waypoints pp1, I use the dedicated ntp page. Thanks for giving the correct name.
Recommended Posts