Low CPU and GPU usage during VR.

[Cintra]

Hi all, I have my graphics set to the VR function with a few small tweaks sucks as 1024 cockpit res and full preloading.

 

This gives me 30fps, very unstable fps when I am near the ground, I haven't tested at high altitudes.

 

This is at roughly 50% CPU usage, 80% GPU usage. These values vary of course.

 

I find this frustrating, I'd like to have better fps and graphics settings but for some reason am being limited in weird ways.

 

Does anyone know anything about this?

[WindyTX]

With the last update my framerates have literally halved and my gpu usage has similarly halved to 38 from 76 ish, with rift s and a 2080ti.

 

Sent from my HD1925 using Tapatalk

[Cintra]

Ok, hopefully that will be fixed.

[Niehorst]

I saw this problem even before the latest update.

 

This occurs only sometimes. Had to restart DCS and everything was fine again.

I did not have that much time yesterday.

 

I first run a "DCE" Campaign mission with much lower CPU/GPU usage.

After e restart of DCS I tried an instant mission and selfmade TEST-missions right out of the editor.

---> expected CPU/GPU usage and framerates.

 

Using the VALVE Index on a RTX2080ti

[Ala12Rv-watermanpc]

same in 2d monitor.

[WindyTX]

I updated stable today happens the netcode is the same s pre update 2.55. the contrast between the 2.56 and 2.55 is marked. Gpu utilisation is double in 2.55 and frames are 30% higher. I did notice that there was no stuttering in 2.56. Hopefully the update this week will give the best of both worlds.

 

Sent from my HD1925 using Tapatalk