Jump to content

Recommended Posts

Posted

some bug with the gun

 

 

- A2G mode not working anymore, I just have a cross, not the ring and gun don't go in RDY even if I can fire it

 

 

- Gun unfeed when you push master arm off, so you can only go master arm off 3 time, after no more gun

Posted

A2G gun mode only have a cross, no ring with ranging infomations like A10.

 

GSH23-2(the one same as MIG21) only have 3 times feeding capability, because of its mechanical design (feeding is done by 3 gunpowders). No more feeding is possible because the gun can only carry 3 gunpowders.

Deka Ironwork Tester Team

Posted

Point requiring clarification: once the gun is loaded, and assuming it does NOT jam, it should NOT require reloading to use it again?

Motorola 68000 | 1 Mb | Debug port

"When performing a forced landing, fly the aircraft as far into the crash as possible." - Bob Hoover.

The JF-17 is not better than the F-16; it's different. It's how you fly that counts.

"An average aircraft with a skilled pilot, will out-perform the superior aircraft with an average pilot."

Posted
Point requiring clarification: once the gun is loaded, and assuming it does NOT jam, it should NOT require reloading to use it again?

Yup, if U select the gun limitor OFF(on SMS), and it doesn't jam(depend on your luck), U can hold the tigger and fire all 180 rounds in just few secs. In most case the gun need only 1 feed.

Deka Ironwork Tester Team

Posted (edited)
A2G gun mode only have a cross, no ring with ranging infomations like A10.

 

 

ok for the cross, but on the hud, gun don't go rdy

 

 

GSH23-2(the one same as MIG21) only have 3 times feeding capability, because of its mechanical design (feeding is done by 3 gunpowders). No more feeding is possible because the gun can only carry 3 gunpowders.

 

 

just retested, maybe I was too tired when tryed, now it work as expected...

Edited by Harke
Posted
ok for the cross, but on the hud, gun don't go rdy

 

 

RDY mark will be cross out if your plane is out of certain bank & pitch angle.

Deka Ironwork Tester Team

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...