T-pod Slew

[Elof]

When ever I get into the f-16 to do a GUB-12 T-pod run. I run into the problem , where when I slew the targeting cursor over a target. The T-pod will continue to slew and not stop where I want it to. Have I got a setting wrong? I have Slew set to a axis is this perhaps the problem?

 

Sorry should state RDR Cursor Switch - x axis and Y axis are the axis setting for the mini stick. Slew in MFD for radar works fine it is slew in TGP same MFD while in SOI that it continues to slew and only while in TGP

Edited April 15, 2020 by Elof

[TheGreatMothra]

This can happen if you don't assign the TPod screen as SOI before slewing it. If this is the case you'll usually find that the slew speed is very fast compared to what it should be.

 

 

 

The only way I can think that setting slew to an axis could cause this is if your axis neutral position is a little off. In that case setting a dead zone on that axis might help.

[kengou]

I have this issue too and only with the F-16. It’s like the final position after I stop slewing “drifts” for a moment before settling.

[Bouli306]

I have this issue too and only with the F-16. It’s like the final position after I stop slewing “drifts” for a moment before settling.

 

Are you slewing the pod or the HUD. Is the TGP SOI wgen slewing?

[Elof]

Slewing the TGP. TGP MFD is Soi when slewing. Must be my axis as when I use Keyboard to slew it is fine. I t is when I slew with mini stick on hotas to slew it continues to slew when I want it to stop. Logitech X-56 hotas