shaHeen-1 Posted April 16, 2020 Posted April 16, 2020 Hi can you describe in a bit more detail what you have done with the following? - Adjust engine response now dependent on airspeed and altitude - Adjust SD-10 loft trajectory, more smooth, better energy management loft condition: target range 30km and not jamming, pitch = 8.0 degrees - Tweak Radar behavior: If target in notch, will try predict target position with last known target position and target velocit -Support radar AG image FRZ (MFCD OSB R3) Please and thankyou XD
foxwxl Posted April 17, 2020 Posted April 17, 2020 Loft trajectory is using the new loft api, so the loft trajectory is now a ballistic curve, no more "straight line + hard turn + straight line". This will greatly improve the missile energy preservation, and also correctly send the missile into high altitude(which loft truely means). Also SD-10 loft is done by manual, so the pitch angle at launch will determine the loft trajectory(how high the missile will loft), it give U better control at close-med range loft action. Deka Ironwork Tester Team
foxwxl Posted April 17, 2020 Posted April 17, 2020 - Tweak Radar behavior: If target in notch, will try predict target position with last known target position and target velocit The radar will now have MEM function works correctly when target entering notch, although it will no show you any additional symbol on the RDR page or HUD like the APG-73, you can still notice this process when the closure rate fixed on a certain number when target trying to notch U. Radar will try to maintain the lock with predicted target VV, but after certain time if the lock can not be achieved, the lock will be droped, and the notch is achieved. Deka Ironwork Tester Team
shaHeen-1 Posted April 17, 2020 Author Posted April 17, 2020 You missed the last point. Also with loft, target has to be farther than 30km? At angels 30 I got a loft kill on f16 at 30nm yesterday. Also what toggle binds did you guys introduce?
foxwxl Posted April 17, 2020 Posted April 17, 2020 You missed the last point. Also with loft, target has to be farther than 30km? Yes, range has to be greater than 30KM to initiate the loft at current build, but this restriction may be loosen a bit if internal test show good result. Deka Ironwork Tester Team
Recommended Posts