WH Throttle: turning the LED's off when a script stops?

[Lange_666]

I'm adding UMD (pinky on the throttle) layers to some of my profiles to make them +/- as equal to an A-10C profile which i converted from my Cougar Foxy days.

Main reason is to keep various actions tied to +/- the same buttons because the brain is not so willing anymore then it used to be.

And because the brain is not so willing anymore, i forget sometimes in which state the pinky is in and then if it's in the wrong state, the actions i expect to happen don't happen or go wrong.

As a little aid i thought of using 3 of the 5 LED's to display the pinky switch state. Works nice (there are various possibility's to do this) but if i use 3 LED's for each position, there's always a LED that's ON when the script is stopped.

So i then thought of using only 2 LED's, one for pinky forward and one for pinky backwards and none for pinky in the middle so if the pinky is switched to the middle position, the LED's from either forward or backward goes out and when none of the LED's are on it's in the middle. But then i thought again that it would be nice to have a LED on when the pinky is in the middle position so i was back at square one.

How to get that last LED turn off "without" using another button press to turn the LED's off (because that's not what I am after).

There's options to set them in various states when the script starts but is there a way to turn them off when a script is stopped to "kill" that last surviving LED?