Mustang25 Posted May 24, 2020 Posted May 24, 2020 (edited) When in Nav master mode, S2 left will cycle RWS, TWS, VS, and MAP but it will not repeat. So I can keep pressing until it gets to map but will not roll back to RWS, etc. Is this intended or a bug? in Air to Air master mode it will cycle through all of the appropriate radar modes properly. Edited May 27, 2020 by L0op8ack
Tiger-II Posted May 27, 2020 Posted May 27, 2020 I reported this months ago, but I think it got lost. Initially it cycled: RWS - TWS - VS - MAP - SEA - MAP - SEA - MAP - SEA and got stuck in the ground modes. Motorola 68000 | 1 Mb | Debug port "When performing a forced landing, fly the aircraft as far into the crash as possible." - Bob Hoover. The JF-17 is not better than the F-16; it's different. It's how you fly that counts. "An average aircraft with a skilled pilot, will out-perform the superior aircraft with an average pilot."
L0op8ack Posted May 27, 2020 Posted May 27, 2020 fixed In EMMC NAV mode, S2_left radar submode cycle will depend on radar main mode: radar in INTC main mode, cycle between RWS/TWS/VS; radar in AG main mode, cycle between MAP/GMTI/SEA1/SEA2/TA/WA/AGR; press OSB_U1 for main/sub mode select(INTC/AG only, DGFT mode cannot manually select);
Recommended Posts