[REPORTED EARLIER] AACQ

[Cypher1773]

Enter AACQ when press sensor control switch right, although radar page on the left DDI.

It should be only press sensor control switch left.

[Darcwaynard]

When in A/A mode SCS right will select AACQ. Left selects WACQ.

 

From Chucks Guide:

 

AACQ (Automatic Acquisition): AACQ serves as a fast way of acquiring a track/contact into Single Target Track. It is entered by pressing the Sensor Control Switch right when

 

the TDC is assigned to the RDR ATTK format, the A/A master mode is engaged, and the radar is not in an ACM mode. "AACQ" will be indicated on the RDR ATTK page and the

 

HUD. If the TDC cursor is not over a contact/track, AACQ will place the closest presently detected contact/track in an STT. If the TDC cursor is over a contact/track, it will place

 

it in STT.

 

Sent from my SM-A530W using Tapatalk

[Harker]

The OP is correct. SCS towards the Radar page should command AACQ.

 

SCS Left entering WACQ requires that you're in ACM mode already, so it requires SCS Forward beforehand.

 

Also, AACQ priority goes TUC > L&S > Rank > Other, AFAIK.

[Darcwaynard]

The OP is correct. SCS towards the Radar page should command AACQ.

 

SCS Left entering WACQ requires that you're in ACM mode already, so it requires SCS Forward beforehand.

 

Also, AACQ priority goes TUC > L&S > Rank > Other, AFAIK.

My bad I misinterpreted the doc then thanks for clarifying.

 

Sent from my SM-A530W using Tapatalk