[FIXED] WMD-7 Pod Skips BIT on cold start and re-arm.

[J20Stronk]

When starting the plane cold: loading DTC, turning on CLDP and the WMD-7 pod after engine start will skip it's BIT test and enter STBY mode.

 

If you press any MFCD button on the POD page before turning on CLDP on the AAP, the pod will run the BIT normally.

 

If re-arming to attach a WMD-7, the same thing will happen after updating SMS:

 

>CLDP on

>WMD-7 on

>BIT will skip and pod enters STBY

 

Once again, pressing any button on the MFCD POD page before "CLDP on" will make the WMD-7 run the BIT.

 

.trk below.

JF POD skips BIT.trk

Edited August 16, 2020 by uboats

[L0op8ack]

fixed

[J20Stronk]

It still skips the BIT if I attach the pod when re-arming.

If the Pod was not pre-attached in the ME and I load it before performing a cold start, the BIT will be skipped

 

If the pod was equipped in the ME, it runs the BIT normally.