Human RIO Radio Volume

[JabbyJabara]

The axis nor the keybindings for the volume control in RIO pit are responding. I can get the forward radio to respond to keybinding INC DECRE but neither of the axis respond to my VIRPIL CM50 throttle axes and the rear radio does not respond to keybinding or axis.

[goldleader]

As per Jabby's Post

The Default Keybinds in the RIO Pit for the ARC-159 seem to be fine, but the Default Keybinds are broken for the ARC-182

 

With the ARC-182 the increase and decrease keybinds seem to control the Squelch switch on or off depending on where you put the Radio Volume

 

If Radio Volume (using Mouse) is above 50% both keybinds turn the Squelch On

If Radio Volume (Using Mouse) is below 50% both keybinds turn the Squelch Off

 

Video Attached showing that I do not have anything bound to the Squelch switch

I use Num 0 and Num . first to change the volume of the ARC-159 Radio and all is well.

 

Then I use Num 1 (Decrease Volume Keybind) for the ARC-182 with the volume below 50% and the Squelch goes off, then I roll the Volume up above 50% and use Num 1 again and squelch turns on

 

Then I do the same thing but using the Num 2 (Increase volume keybind) and the squelch switch goes off below 50% and on above 50%.

 

Edited August 22, 2020 by goldleader
sorting out embedding the video