VNAO T-45 Issues

[Aviatorskate]

Having some issues with new t-45 free mod. I can fly off the carries and spawn in the air. I can't get the plane working right on the ramp.

I can get the engine started but no throttle response on RPM indicator, throttle moves in sim. I also cannot reset Hyd2, No HUD and No Right MFD.

Any Ideas ?

 

Thanks

[AndyJWest]

Make sure you have moved the master engine switch back to 'on' from 'start' once the engine is running.

Edited May 3, 2021 by AndyJWest

[Aviatorskate]

I will try again this afternoon and let you know.

 

Thanks

[Mars Exulte]

I vaguely remember on the old Hawk module, I think you could accidentally take it out of idle detent too soon. Also the HYD reset, but you mentioned that so I assume it's working properly.

 

I dunno how much crossover there even is between T1 and T45 though.

 

[Aviatorskate]

That didn't work. Engine stays at 30 %. If I select start switch to off, engine dies.

 ??????

[Aviatorskate]

Got it working. Needed to program another button for "Start Switch ON" to get it off of "Start" and not "OFF"

 

Thanks

[AndyJWest]

Yup, it's a three-way switch. 

 

Incidentally, you'll be better off asking for help in the T-45 thread, rather than in the general DCS world subforum, if you have problems with the mod. People with relevant knowledge may not see it here.

https://forums.eagle.ru/topic/203816-vnao-t-45-goshawk/#comments

 

[Aviatorskate]

ok thanks

[Aviatorskate]

In the real aircraft the start switch is a momentary contact switch spring loaded back to the "On" position.