Jump to content

Dynamic gates for Afterburner and Engine Cut-off Detents


-archer-

Recommended Posts

Greetings!

We have detents in TM Warthog Throttle and in VPC MongoosT-50CM3 Throttle. And VKB TECS is coming - with electronic dynamic detents.

Is there any possibility to get dynamic detents zones in DCS World like those in Microprose/BMS  Falcon?

 

i7-6700k (4.7 GHz) // RAM 32 Gb // GTX 1070 // // Windows 10 64-bit LTSB;

VKB Gunfighter Mk2 Pro + VKB MCG Pro // BRD-F1(v.2) // Oculus Rift cv1 // BRD-N(v. №4) // VKB King Cobra MkII Fat // VKB King Cobra MkIII Fat // Saitek X55 // Saitek throttle Quadrant // Microsoft FFB 2 // Saitek X45 // Thrustmaster HOTAS Warthog // VKB MK20-3 Pro Pedals // VKB RDRXXI-L // TrackIR 5

Link to comment
Share on other sites

Well. I saw a forsage detent was mentioned. But what about a cut-off detent?

i7-6700k (4.7 GHz) // RAM 32 Gb // GTX 1070 // // Windows 10 64-bit LTSB;

VKB Gunfighter Mk2 Pro + VKB MCG Pro // BRD-F1(v.2) // Oculus Rift cv1 // BRD-N(v. №4) // VKB King Cobra MkII Fat // VKB King Cobra MkIII Fat // Saitek X55 // Saitek throttle Quadrant // Microsoft FFB 2 // Saitek X45 // Thrustmaster HOTAS Warthog // VKB MK20-3 Pro Pedals // VKB RDRXXI-L // TrackIR 5

Link to comment
Share on other sites

You can set custom detents using curvature in your throttle axis tune. Just rescale everything so the detent ends up where you want it. It's not as straight forward as in the sim that shant be named, but it's a relatively quick workaround.

-Col. Russ Everts opinion on surface-to-air missiles: "It makes you feel a little better if it's coming for one of your buddies. However, if it's coming for you, it doesn't make you feel too good, but it does rearrange your priorities."

 

DCS Wishlist:

MC-130E Combat Talon   |   F/A-18F Lot 26   |   HH-60G Pave Hawk   |   E-2 Hawkeye/C-2 Greyhound   |   EA-6A/B Prowler   |   J-35F2/J Draken   |   RA-5C Vigilante

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...