NaCH Posted August 31, 2021 Posted August 31, 2021 When in TWS, and sensor and do SCS to the right again with the TDC in a blank space without contact the radar goes in to AACQ but does not lock anything and the legend stays there. To reset it I have to go SCS left and go into AZ/EL mode and in the left DDI and then the AACQ legend disappears in the right DDI radar and hud. Is this correct?
Jak525 Posted September 1, 2021 Posted September 1, 2021 Yeah, there's a missing ability to hit Undesignate to leave AACQ. Only really need it in this scenario where you have zero trackfiles, but still would be nice. 1
Eclipse Posted July 31, 2022 Posted July 31, 2022 Found this while looking for something else, so in case it helps someone... It's covered in the manual - hit the reset button on the radar DDI page and you will exit AACQ. There are a few other ways, also. AMD 9800x3d, RTX 5090, 64GB 6000MT/S DDR5 RAM, Samsung 9100 Pro SSD, HP Reverb G2 version 2, CH Fighterstick, Pro Throttle, Pro Pedals, and a Logitech Throttle Quadrant. Next up, a Pimax Crystal Super (I think. At some point. )
rfxcasey Posted August 1, 2022 Posted August 1, 2022 Just SCS down and then back to the direction of the DDI in question. Becomes second nature after a while.
Recommended Posts