Some Key Binds only work from Nav Seat

[Olddog]

For example.

The T1154 transmitter low and high voltage switch, from the pilot seat, I can't mouse click on it, the pointer stays yellow, and no "tool tip" 

 

Jump into the Nav seat, (after looking around the brass knob), no problem with turning them on/off

 

Tried to bind some keyboard commands, (Lalt+Lshift+R), will not work from Pilot seat,

Works from Nav seat. 

 

All the above applies to all the controls on T1154 and T1155 R/T equipment in the back..

From the pilot seat I can't use the mouse or keybinds,  Nav seat works.

 

Should this be in the bug section or am I missing something.

Sure hope it's not  going to be "correct as is"

This is in SP, don't know about MP

[Olddog]

Well I guess this is "correct as is".

Apparently I didn't read the memo but all the controls and switches are set up were some are pilot seat only, some are from the  Nav seat only and the rest are both pilot and nav.

 

[No1sonuk]

It's a PITA if you're on your own trying to fly and run the RDF.

[bart]

15 minutes ago, No1sonuk said:

It's a PITA if you're on your own trying to fly and run the RDF.

 

Agreed, it's a hand full trying to do two crew member's jobs at the same time especially the radio's which require a bit of concentration. One of the reasons I've put this suggestion on the wish list, see what you think.

 

Edited September 25, 2021 by bart

[Bozon]

Key binds should work from any seat - you don’t get different key binds set for each seat, so I can’t see the sense making some keybinds seat dependent. Mouse clicks may be seat-dependent.