LANDSTÄLL gear config warning not working correctly.

[Snappy]

Dear Heatblur/ @IronMike

 

the landing gear config warning light LANDSTÄLL is not working correctly at all.

 

According to your own manual (page 82)  :

 

 

 

The first and the third condition are both not simulated correctly. The others are hard to test due to the abnormal configuration required for them.

-The  first condition in DCS during normal gear extension the LANDSTÄLL is not illumating solid as it should, but instead flashes.

 

-The third condition seems to be not modelled at all. You can decelerate with idle throttle (at less than 1500m alt) to even below 300 km/h and still you get neither a flashing LANDSTÄLL nor a Master Caution. (this one has been reported before in 2017 and went under or is still/again bugged)

 

I attached a track. You can see all 2 (3) issues. Not sure if you need the mission file too, I attached it as well, just a custom take off scenario.

After take off I decelerated at below 1500m alt with idle throttle and even far below 375 km/h no master caution and nó flashing LANDSTÄLL.

then I recovered ( barely )   and did a normal gear extension at the end of the track. You can see the LANDSTÄLL light flashes instead of indicating solid.

 

 

As for take off, you can see it flashes also during gear retraction . I m not sure about this, the manual makes zero mention of take off behaviour but I would venture a guess, that the light should also be illuminating solid during normal gear retraction as a flashing light  seems to be associated to warnings and abnormals.

 

Kind regards,

Snappy

 

Landstall3.trk ViggenTakeOff.miz

Edited September 25, 2021 by Snappy

[IronMike]

Thank you for the detailed report, Snappy. I tracked it.