Request info about Tle5010 Teensy++ and MMjoy2

[inigohe]

Best regards from Spain..

Im trying to conect tle 5010 sensor to Teensy++ upgraded with MMjoy2 firmware, but I have not success. The model I have its the chinese one.

There is some kind of issues about those hardware? I seen the pins CS and Miso are no placed correctly.

Someone can explain me where I have to conect .

Thx in advance.

Ignacio

Edited September 29, 2021 by inigohe

[Tanuki44]

Compared with a connection on Promicro

 

https://simhq.com/forum/ubbthreads.php/topics/4508405/joysetup-mmjoy2

 

The GEN pin is not connected to MOSI...

Edited September 29, 2021 by Tanuki44

[Tanuki44]

the GEN Pin seems to be B6 on Promicro and Teensy ++ 2.0

 

https://forum.il2sturmovik.ru/topic/4664-mmjoy2-бесплатная-прошивка-и-софт-для-самодельного-контроллера-джойстика/page/2/

 

 

Edited September 29, 2021 by Tanuki44

[inigohe]

Thx...great will try tomorrow

Ignacio

[inigohe]

Regards...

Failed,  the sensor doesn´t appears connected... Latest version of MMjoy2 instaled.

 

Tle5010	Teensy ++ 2.0
+	Power
CS	F0 (Analog Inputs)
-	Ground
Miso	B3
Sck	B1
GEN	B6

Tried with two diferent sensors...I purchased a set of two,...Magnet is axial.

Datasheet tle 5010

 

http://static6.arrow.com/aropdfconversion/8b0dd5185ea080c3168cf0e523144274b37465e3/tle5010_preliminary_data_sheet_v0.9_draft.pdf

 

Teensy ++2.0 board pinout for MMJOY2.

 

 

No idea how to solve those peski trouble.

Let me know if someone has experimented the same and how did u solve it!!!

Thx.

Ignacio

 

 

Picture of the tle 5010 sensor I have...

Edited September 30, 2021 by inigohe

[Tanuki44]

Too bad it does not work, I can not help you anymore, I only use Promicro and SS495A.

[crash test pilot]

Do you have a multimeter to check if the labeling for the pins on the tle5010 board is correct? I remember reading somewhere about mislabeled pins on some of these boards. The setup is correct, just tested on mine and it works.