Jump to content

Recommended Posts

Posted (edited)

Hi! In Controls/UI Layer there is a binding for that ("Recenter VR headset" is called), and of course works in all modules. Be careful not to pick a key (or HOTAS button) that is use for other thing in a module).

I use a button in my throttle.

Edited by nachomaga
Posted
2 hours ago, nachomaga said:

Hi! In Controls/UI Layer there is a binding for that ("Recenter VR headset" is called), and of course works in all modules. Be careful not to pick a key (or HOTAS button) that is use for other thing in a module).

I use a button in my throttle.

 

I talked about a WMR center button, not DCS 🙂

 

thanks btw

Posted

I don't think there is a command to recentre the wmr headset short of restarting the wmr portal or running the room setup again.

I've never had an issue with it unless I've lost 6dof tracking due to lack of light but the extra cameras on the G2 compared to the Lenovo explorer before have pretty much eliminated that problem.

Ryzen7 7800X3D / RTX3080ti / 64GB DDR5 4800 / Varjo Aero / Leap Motion / Kinect Headtracking
TM 28" Warthog Deltasim Hotas / DIY Pendular Rudders / DIY Cyclic Maglock Trimmer / DIY Abris / TM TX 599 evo wheel / TM T3PA pro / DIY 7+1+Sequential Shifter / DIY Handbrake / Cobra Clubman Seat
Shoehorned into a 43" x 43" cupboard.

Posted
9 hours ago, edmuss said:

I don't think there is a command to recentre the wmr headset short of restarting the wmr portal or running the room setup again.

I've never had an issue with it unless I've lost 6dof tracking due to lack of light but the extra cameras on the G2 compared to the Lenovo explorer before have pretty much eliminated that problem.

I use a motion cancelation software for my 6DOF platform and I often need to reset seated position when I start my game to have this software to work.

 

Without this, center view in DCS is enough.

 

thanks 🙂

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...