HMCS coarse alignment does not stop on release of "Enable" button when Align OK.

[SnappyComebacks]

Trackfile: https://we.tl/t-Qv76S1JNSb  (WeTransfer service.  Expires one week from posting.)  Trackfile is 6MB (too big for forum, sorry)

Edit:  Added second trackfile from new mission with only F16 in it.  (Small enough to attach)

Setup:

• Instant Action - F16 - Caucasus - Cold and Dark
• Performing a cold start in the F16.
• All systems are ready from normal startup, except for HMCS.

 

Expected Behavior:

Upon release of `Enable` key command after receiving `Align OK` when performing course alignment, the HMCS alignment position should be set.

 

Current Behavior:

Pressing `0` on the ICP after receiving `Align OK` to progress to Az/El alignment sets the position of the coarse alignment.  This makes your coarse alignment misaligned if you turn your head to press `0` on the ICP.

Here is a video showing the current behavior.  Video shows full cold and dark start, feel free to skip to HMCS alignment:

 

To Reproduce:

1. Start a cold and dark jet completely, except for HMCS.
2. Turn on HMCS.
3. Navigate to the HMCS DED page.
4. Dobber right to the coarse/az-el/roll page.
5. Ensure coarse is highlighted and press `0` on the ICP to start.
6. Align HMCS cross with HUD cross.
7. Hold `Enable` keybind with crosses aligned until seeing `Align OK` and then release `Enable` keybind
8. Move head away from centered HMCS cross
9. Press `0` twice on the ICP to move to `Az/El`
10. Az/EL alignment crosses are set where you are currently looking, instead of where they were set by coarse alignment.

F16_HMCS_Alignment_Issue.trk

Edited January 8, 2022 by SnappyComebacks
Add second trackfile