AV-8B : The coordinates at ODU change and run away.

[Prince3744]

Could someone help me.
I have problem to fill coordinates.
I don't know what I did wrong but it be this after late update.
When I add a waypoint and fill coordinates sometime after that the coordinates at ODU change and run away. That make me can not use TPOD to point a target.

[Ramsay]

This part of the forum is intended for more General/generic DCS 2.7 bugs and problems (so is less likely to be seen by Razbam)

A better location for an AV-8B bug report is https://forum.dcs.world/forum/514-problems-and-bugs/

Detail

I haven't seen this particular problem before, are there any other waypoints loaded in the aircraft ?

Can you upload a short track that demos this or upload a longer video to youtube showing what you did prior to trying to create a new waypoint.

[Ramsay]

13 hours ago, Prince3744 said:

Now I can not add waypoint!?

Your waypoint co-ordinates were rejected - they are invalid i.e. seconds were greater than 59.

• N 42° 24' 86"
• E 041° 34' 72"

I'm not sure what exactly you are trying to do as I can't read the TPOD co-ordinates in the low res 480p video but if you are copying the TPOD's co-ordinates, they are in a different format "Degrees Decimal Minutes" to the EHSD's waypoint Lat/Long data entry which expects "Degrees Minutes Seconds".

This video might help if you're attacking targets of opportunity i.e. stuff spotted using the TPOD

Edited March 12, 2022 by Ramsay
typo

[Prince3744]

You right. When I fill coordinates less than 60 I can add waypoint.

Thank you.

But sometime the coordinates at ODU still run away. 

Edited March 17, 2022 by Prince3744