Varry007 Posted March 30, 2022 Posted March 30, 2022 I was messing though the menus of the AH-64D while in flight; apparently, I disabled generator 1 and 2: which cut all electrical power to all electronics. To my surprise; the chopper kept flying; trimming was still possible; and I managed to land it. But it was impossible to re-enable those generators as they are activated through a menu, which after disabling the generators; is no longer reachable. Is there a way to re-strat them through a button? Or is it some kind of Doom-function?
Solution tech_op2000 Posted March 30, 2022 Solution Posted March 30, 2022 reenabling the generators requires using the generator reset switch located in the bottom middle of the pilots cockpit, just above the wipers control.
ED Team Raptor9 Posted March 30, 2022 ED Team Posted March 30, 2022 As tech_op2000 mentioned, the reset switch in the pilot cockpit is used to turn the generators back on. As you have observed, you lose MPDs when you lose generator power, therefore this physical switch is required. Afterburners are for wussies...hang around the battlefield and dodge tracers like a man. DCS Rotor-Head
Varry007 Posted April 1, 2022 Author Posted April 1, 2022 On 3/30/2022 at 6:26 PM, tech_op2000 said: reenabling the generators requires using the generator reset switch located in the bottom middle of the pilots cockpit, just above the wipers control. thank you all for your feedback!! DCS has the best community!
Recommended Posts