Jump to content

disable generator 1 and 2


Varry007
Go to solution Solved by tech_op2000,

Recommended Posts

I was messing though the menus of the AH-64D while in flight; apparently, I disabled generator 1 and 2: which cut all electrical power to all electronics. To my surprise; the chopper kept flying; trimming was still possible; and I managed to land it. But it was impossible to re-enable those generators as they are activated through a menu, which after disabling the generators; is no longer reachable. Is there a way to re-strat them through a button? Or is it some kind of Doom-function?

Link to comment
Share on other sites

  • ED Team

As tech_op2000 mentioned, the reset switch in the pilot cockpit is used to turn the generators back on. As you have observed, you lose MPDs when you lose generator power, therefore this physical switch is required.

Afterburners are for wussies...hang around the battlefield and dodge tracers like a man.
DCS Rotor-Head

Link to comment
Share on other sites

On 3/30/2022 at 6:26 PM, tech_op2000 said:

reenabling the generators requires using the generator reset switch located in the bottom middle of the pilots cockpit, just above the wipers control.

thank you all for your feedback!!

 

DCS has the best community!

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...