Fanatec Clubsport V3

[Lenux]

I just received the Fanatec Clubsport V3, tested with some racing simulators, it's a huge difference between the rudder pedals for racing sim

I did a quick test with MSFS 2020, everything is fine, can use the V3 pedals as rudder but I can't find a solution for DCS World 

Is there a way, without a 3rd party software? 

Thank you 

[Default774]

I have Fanatec CSL LC pedals and I ran into the same problem you did. I used to use G29 pedals which, with some axis tune trickery, could be used as rudders. After upgrading to Fanatec pedals I found its no longer possible.

I don't think there is a way to do it without 3rd party software sadly.

I ended up using Joystick gremlin to merge the clutch and throttle together. In the end this is a better solution than using in game axis trickery even if it was possible as it allows you to press both pedals at the same time without getting jitter from the axis input switching.

[Lenux]

I tried with Joystick Gremlin, as well 

Can't make it work. Maybe I'm doing something wrong, I don't know. 

Could you please give more details about this? 

[Default774]

I have the pedal Z-axis(clutch) set as upper half and X-axis(throttle) as lower half. However, you should do it the other way around because the way I have set it up requires you to invert the axis every time, which is a minor inconvenience!

Edited August 21, 2022 by Minimalist

[Lenux]

Finally

Thank you so much, Minimalist. You're my hero

Is there a way to copy the F5E rudder profile ( I tried with F5E ) for all the aircrafts I own ?

Second question : do I need to keep open the Joystick Gremlin software, for flight sims, right ?

Thank you, again

Edited August 21, 2022 by Lenux

[Default774]

12 minutes ago, Lenux said:

Is there a way to copy the F5E rudder profile ( I tried with F5E ) for all the aircrafts I own ?

 

Sadly not, you'll have to apply it for every aircraft you own.

13 minutes ago, Lenux said:

Second question : do I need to keep open the Joystick Gremlin software, for flight sims, right ?

Yes. Make sure you save the merged axis as a profile. In Joystick Gremlin settings you can set the program to run on startup and apply your profile on startup. You can also check it to stay in system tray so its out of the way. Side note, the run on windows start up option doesnt work for me, YMMV.

[Lenux]

Thank you so much. 

 

[Knock-Knock]

Can also try this, no external software needed.

 

[Default774]

2 minutes ago, Knock-Knock said:

Can also try this, no external software needed.

 

This doesnt work on some pedals because the axis' are different, for example, this method works fine on G29 pedals, but its literally impossible on fanatec pedals

[Lenux]

I tried this many times but no luck 

Thank you, anyway 

Off topic : why does it work with MSFS 2020, without any external software? 

Edited August 21, 2022 by Lenux